DSR1 Update information

8-Channel Interactive Signal Processor w/ Integrated iDatalink Maestro Module
Post Reply
User avatar
Dara DeGrand
ADS Team
Posts: 4562
Joined: Mon Dec 02, 2013 1:34 pm

DSR1 Update information

Post by Dara DeGrand » Tue May 08, 2018 2:32 pm

Before installation of the DSR1, there are a few steps to take during programming to make sure everything goes smoothly.

First, ensure the main board of the unit is up to date. The DSR1 main board is updated using a PC application, found at the link below. You can use that program to load firmware files found on that page. Upon initial installation, you must FIRST update from the Rockford site, then update on our website.

http://rftech.custhelp.com/app/answers/detail/a_id/1324

Next, update your module through the weblink updater. See the attached image. If the main screen shows an option to update the BLE firmware, do the update first, and then start the configuration on your module, if applicable.
BLE.png
You do not have the required permissions to view the files attached to this post.
Dara DeGrand
Maestro Technical Support Manager
Automotive Data Solutions Inc.
8400 Bougainville, QC
T 514.807.2888
TF 866.427.2999

Post Reply

Return to “Maestro DSR1”