So my steering wheel control is running great, but I hooked up the 2 data wires to the OBD2 port and I am getting 2 errors that cycle between each other when I go to the gauges screen.. My radio reports OBD2 Error 1, OBD2 Not Responding Error.I have the unit connected per the vehicle specific instructions ,CAN H Brown/Red to White (Pin 6) ,CAN L Brown/Yellow to Red (pin 14) . I tried this with the 2 wires from the connector inline, as well as without the 2 wires from the connector spliced in. Both configurations result in the same errors. Any ideas? Thanks in advance.
Honda Ridgeline 2013
iData Link Maestro
Group using the HO1 and HO2 firmware * see specific firmware for full feature list.
2 posts • Page 1 of 1
- New User
- Posts: 4
- Joined: Sat Mar 24, 2018 5:32 pm
- Dara DeGrand
- ADS Team
- Posts: 4562
- Joined: Mon Dec 02, 2013 1:34 pm
The most common reason for this is if you accidentally use the red/brown and yellow/brown, (instead of brown/red and brown/yellow). They are pinned next to each other in the harness and are very similar in color, so it's an easy mistake to make. Can we triple check this?
Maestro Technical Support Manager
Automotive Data Solutions Inc.
8400 Bougainville, QC