2019 Cherokee Back-Up Cam Not Working

Group using the CH1, CH2 and CH3 firmwares for uConnect, steering wheel controls, OEM amplifier retention. compatible with select Mitsubishi and Volkswagen vehicles * see specific firmware for full feature list.
Post Reply
txbengali1980
New User
Posts: 1
Joined: Sat Feb 08, 2020 2:56 am

2019 Cherokee Back-Up Cam Not Working

Post by txbengali1980 »

I am using the Maestro RR and CH3 to integrate a Pioneer w4400 NEX. Most everything works as expected however the factory backup cam shows only a black screen. This is when putting car in R or selecting the Cam. Parking Assistance audible tones and sonar work for the most part but sometimes it doesn't beep. Guide lines also don't show up.

Any help would be greatly appreciated.

fastestneon
12Volt Specialist
Posts: 9
Joined: Sun Nov 25, 2018 5:46 pm

Re: 2019 Cherokee Back-Up Cam Not Working

Post by fastestneon »

So when going into reverse the screen switched over correctly but only shows black right?
If this is correct just make sure your maestro backup camera RCA is plugged into the right port on the Pioneer. It must be labeled Back up camera input (usually a Brown RCA) do not connect to the video input (yellow RCA)
Jeffrey
Lead Installer
Best Buy

User avatar
Dara DeGrand
ADS Team
Posts: 6968
Joined: Mon Dec 02, 2013 1:34 pm

Re: 2019 Cherokee Back-Up Cam Not Working

Post by Dara DeGrand »

If you trace the backup camera video RCA back into the CH3 t-harness, are there wires populated on the vehicle side? Do you have the yellow backup camera RCA plugged into the brown RCA port?
Dara DeGrand
Maestro Technical Support Manager
Automotive Data Solutions Inc.
8400 Bougainville, QC
T 514.807.2888
TF 866.427.2999

Post Reply

Return to “Dodge, Chrysler, Jeep”