2019 Ram 1500 w/out Amp w/ANC

8-Channel Interactive Signal Processor w/ Integrated iDatalink Maestro Module
Post Reply
jjgrady12
New User
Posts: 1
Joined: Sun Jan 05, 2020 10:54 am

2019 Ram 1500 w/out Amp w/ANC

Post by jjgrady12 »

Hey folks -

Installed a new DSR1 w/the dch3 harness into a RAM 1500 w/out Amp w/ANC.

8" Screen

Installed a JBL AMP, JL Sub, new JBL Speakers in doors and Kenwood 3.5 in the dash.

It all works ONLY if I run the Rockford Firmware updater and select Factory Default on Firmware upload.

When I go to the Idatalink Maestro updater and select vehicle specific (Ram 1500 2019, w.out Amp w/ANC) I then get the amp turn on for about a minute, then off. No sound.

Erase the config using Rockford DSR1 Updater to factory default, sound again.

What gives! :?

User avatar
billr
ADS Team
Posts: 635
Joined: Mon Feb 05, 2018 9:18 am

Re: 2019 Ram 1500 w/out Amp w/ANC

Post by billr »

Did you connect the wires at the CAN Junction block like described in the instructions? We sypply a "T" adapter so you unplug one of the connectors there at the junction block, place out "T" harness in-line and connect it to the DSR1 harness.
Ram 2.PNG
also after that you need to program the vehicle as described in the instructions:
Ram.PNG
You do not have the required permissions to view the files attached to this post.
William (Bill) Repicky
Automotive Data Solutions Technical Support
MECP Master Certified
ASE A6 Certified
866-427-2999

Post Reply

Return to “Maestro DSR1”