2010 Prius w/o JBL

Group using the TO1 and TO2 firmware * see specific firmware for full feature list.
Post Reply
New User
Posts: 1
Joined: Sat Dec 08, 2018 10:55 am

2010 Prius w/o JBL

Post by GreyGhost » Sat Dec 08, 2018 11:30 am

I saw a post concerning an issue with a 2011 Prius that was described exactly like my problem. I installed a Pioneer MVH2400NEX with the Maestro RR. The problem is this: When the car is shut off, the radio stays on and the car beeps upon exiting, as if you left the keys in the ignition. My fix was to disconnect the red 12V ACC wire on the harness that connects to the Pioneer. It worked and the radio has all normal functions. But, I am not comfortable with this "bandaid" fix. In the post I saw the person was using a Kenwood with the Mestro RR. Same fix?

ADS Team
Posts: 249
Joined: Mon Jan 15, 2018 2:18 pm

Re: 2010 Prius w/o JBL

Post by JustinFerroni » Sat Dec 08, 2018 1:43 pm

on your TO1 harness you are going to need to remove the step up resistor that jumps across the 12v ACC wire and the K-Line wire. It is located under the white QC sticker under the tape. Cut all the tape and you will see where the two wires are joined together. simply remove the resistor and tape everything up
Justin Ferroni
Technical Support Specialist- Maestro
T: 514.807.2888
TF: 866.427.2999

Post Reply

Return to “Toyota”