programming CS remotes to the HCF controller

Sold exclusively by Firstech/Compustar
Available in Canada and USA
Post Reply
Aporter
12Volt Specialist
Posts: 4
Joined: Sat Jun 23, 2012 1:35 pm
Location: Black Earth WI
Contact:

programming CS remotes to the HCF controller

Post by Aporter » Sat Sep 17, 2016 1:41 pm

Guessing I have a learning curve here. Only second HCF controller I've ever used, and the first one I've tried programming CS remotes to. 08 Pathfinder with alarm, standard key. NI4 install and the ftd100 was flashed. Swapped remotes (pro 902 and companion G7), swapped decoders (flashed again), reset controller, swapped blue cable for decoder, swapped ant cable, swapped antenna. I can't find the instruction for programming CS remotes, but I'm assuming it's the same as CS controllers, ignition on/off 5 times. Red led on controller when I do that, but it does not react to the remotes at all and times out. What am I not doing correctly here? Thanks
Adam Porter
Owner/Installer
On The Go Tech
1529 State Street STE F
Black Earth WI
608-767-4477
AdamPorter@On-The-Go-Tech.com
On-The-Go-Tech.com
MECP Advanced Certified Installation Technician

User avatar
Murph
Site Admin
Posts: 7285
Joined: Sun Oct 23, 2011 8:35 pm

Re: programming CS remotes to the HCF controller

Post by Murph » Thu Sep 22, 2016 11:43 am

Adam I know you already got your answer. For anyone else looking for this on the HC-F product. It's off to on 5 times ending in the ON position.

All guides are being updated as we speak. Sorry for the inconvenience.
Brian Murphy
MECP Advanced Certified Installer
ADS Tech Support
Automotive Data Solutions inc.
8400, Bougainville, Montreal, QC.
1-866-427-2999
support@idatalink.com

Post Reply

Return to “iDatastart HCF”