My name is Aaron Mcmullin, and I am a installer in New Glasgow Nova Scotia running a small installation bay for a local Ford and Nissan dealership.
I had just installed a HCX ( flashed to the current firmware via Idatastart website ) unit in a 2014 PTS Pathfinder as a standalone unit ( 3x lock ) and was just informed by the customer at approximately 10-15 mins into the runtime the horn starts blowing. He also states this occurs after pressing lock 3x to shut off vehicle.
I believe this is a possible rap issue, but wondering if I could get some input before bringing him back in to troubleshoot further. During testing, this issue never arose, although I only let the vehicle run for a few minutes before remotely shutting it off. The radio and auto lights also shut off after I had shut it off.
On a side note, there were no arm and disarm wires present in the bcm, if this matters. And I did not insert pins into the bcm.
Thanks in advance for any information.
Available in Canada and USA
2 posts • Page 1 of 1
- Site Admin
- Posts: 6546
- Joined: Sun Oct 23, 2011 8:35 pm