Available in Canada and USA
1 post • Page 1 of 1
- 12Volt Specialist
- Posts: 41
- Joined: Sat Nov 21, 2015 1:39 pm
- Location: Grunthal, Manitoba, Canada
I'm installing a HCX unit and in the hardwire diagram it says the disarm wire should go to lt blue/black wire on pin 9. However there is no wire in the spot. And I am at the black 26pin in the back of the BCM/Fuse Block. Suggestions? There is a lt blue/black wire in a 52 pin connector on the front of the BCM.