Communication Error
-
- 12Volt Specialist
- Posts: 126
- Joined: Wed Sep 15, 2010 9:30 am
- Location: Kustom Workz 5035 Transit rd Depew, NY 14043
Communication Error
When trying to flash the CM7000 in my wife's Highlander I get a communication error. The only way I could get it to work was by disconnecting the module from the vehicle. I was then able to change settings on the BladeAL and configure the starter. Is this normal? Just a bit of info for ya. If you leave the trunk/hatch release turned on in data it will only open the rear hatch slightly. Turn it off and power rear hatch operates normally.
It is what it is.
Shawn Stoddard
Basil Toyota
6179 S Transit rd
Lockport, NY 14094
716-625-8444
Shawn Stoddard
Basil Toyota
6179 S Transit rd
Lockport, NY 14094
716-625-8444
- Murph
- Site Admin
- Posts: 6866
- Joined: Sun Oct 23, 2011 8:35 pm
Re: Communication Error
You can't flash a module when it's installed in the vehicle. You have to remove power.
Brian Murphy
MECP Advanced Certified Installer
ADS Tech Support
Automotive Data Solutions inc.
8400, Bougainville, Montreal, QC.
1-866-427-2999
support@idatalink.com
MECP Advanced Certified Installer
ADS Tech Support
Automotive Data Solutions inc.
8400, Bougainville, Montreal, QC.
1-866-427-2999
support@idatalink.com
-
- 12Volt Specialist
- Posts: 126
- Joined: Wed Sep 15, 2010 9:30 am
- Location: Kustom Workz 5035 Transit rd Depew, NY 14043
Re: Communication Error
Gotcha.
It is what it is.
Shawn Stoddard
Basil Toyota
6179 S Transit rd
Lockport, NY 14094
716-625-8444
Shawn Stoddard
Basil Toyota
6179 S Transit rd
Lockport, NY 14094
716-625-8444