web link update??

Post by **Minty** » Mon Sep 08, 2014 11:06 am

Hi guys I finally got the weblink mobile and when i plug it in needs a an upodate as its 1.1 and needs 1.4(or somethinig like that). When i click ok to to update it comes with an error to the tune of "serial not supported" now this is with no ADS module hooked up. If i go past that it just has a memo stating not to unplug .. I have watied for 30 minutes and nothing..
* Note: I have a new iPhone 5c*

thanks

Post by **Murph** » Mon Sep 08, 2014 11:36 am

Update it on the PC.

Post by **Minty** » Mon Sep 08, 2014 12:07 pm

Thanks for the reply. Is there way to do this. Where do I find the info to do this

Post by **Murph** » Mon Sep 08, 2014 12:22 pm

Unplug the 4 pin cable from your weblink USB on the PC. Then plug your weblink mobile into the weblink PC flasher. Go to the website and hit flash your module. it will detect the flasher. Then flash the new firmware.

Post by **Minty** » Mon Sep 08, 2014 1:45 pm

Ah. I was just thinking that myself. Was wondering how to plug into PC. Thanks for your assistance.

Post by **Minty** » Mon Sep 08, 2014 2:17 pm

I just tried what you had said and it says "device not recognized". Am I to have power to the weblink mobile unit via the power cord.

Post by **Minty** » Mon Sep 08, 2014 2:45 pm

I tried with power hooked up to weblink mobile unit and it says to contact tech support.

Post by **Murph** » Mon Sep 08, 2014 3:05 pm

So you called 1.866.427.2999, right?

Post by **Minty** » Mon Sep 08, 2014 3:07 pm

No I have not. In middle of installs. Will make time to call. Thanks for your assistance none the less.

Post by **Murph** » Mon Sep 08, 2014 3:16 pm

I try to help people here on the forum but nothing can replace real time tech support.

Post by **Minty** » Mon Sep 08, 2014 8:13 pm

Kind of weird Brian but I might have talked to you. If not the other Brian I spoke with said that we may have a version that is not supported. Or we have a bad weblink mobile module. Going to get new one at the warehouse and try from there. Just want to get this working before it gets too cold. Thanks again

Post by **Murph** » Mon Sep 08, 2014 9:57 pm

Minty wrote:Kind of weird Brian but I might have talked to you. If not the other Brian I spoke with said that we may have a version that is not supported. Or we have a bad weblink mobile module. Going to get new one at the warehouse and try from there. Just want to get this working before it gets too cold. Thanks again

Yes sir there is only one Brian. This is strange for sure. Let me know how it works out when you get another weblink.

web link update??

web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??

Re: web link update??