Page 1 of 1

Flashing Procedure for iDatalink Maestro RR Interface Module

Posted: Wed Jan 06, 2021 5:27 pm
by dangerruss
I will be installing a Pioneer DMH-W4660NEX in a 2012 Jeep JKU Rubicon. Can I flash/program my new iDatalink Maestro RR Interface Module without being installed in my vehicle? I started the process and seemed like the installation was asking me to press the buttons on my steering wheel. I may have misunderstood the process. Please help. Thanks in advance,,,

Re: Flashing Procedure for iDatalink Maestro RR Interface Module

Posted: Wed Jan 06, 2021 7:40 pm
by Dara DeGrand
Flash the maestro, then install in the vehicle. It will ask you to confirm what your steering wheel looks like when you're flashing, but that's about as complicated as it gets. Any questions, just give our tech support line a shout.

Re: Flashing Procedure for iDatalink Maestro RR Interface Module

Posted: Thu Jan 07, 2021 12:45 pm
by dangerruss
Thanks...